Notes on the changes in the mapping:

v0.1.1

-Removed de-tent setting for the first filter on the left side of the controller. This knob is now set to full range just like all other knobs.

-Use the Midi Fighter Utility software to change your "ON" and "OFF" colors of the RGB LED under the knobs. By default, the colors are set to match effects in the quick guide pic under the text but you can use MF Utility to easily change those to any of other available colors.
    
-Activating effects will result in pulsating LED indication. Solid LED stands for deactivated effects.


v0.1.2

-There are two Mapping Devices in total.

-Removed the "Send Monitor State" command from the Encoder Pushbutton mappings which was used to sync LED Rings with the modifiers. Instead, entire mapping is now switched to 3Fh Encoder mode. 

-Row#2 / Encoder#4 doesn't close the Dry/Wet parameter once it's deactivated. It is now possible to leave a tail behind the Reverb.

-Row#3 / Encoder#2 is mapped to Ramp Delay. Once it's activated you can twist Encoder#4 to adjust the Dry/Wet. Same as Delay T3 originally (Encoder#1).

-Row#3 / Encoder#4 is remapped to Freeze Echo.
 Push = Freeze
 Twist = Rate/Speed Adjust 

-Row#4 / Encoder#3 is remmaped for new Beatmasher combo (FX buildup style).


v0.1.3

-Fixed 2nd Beatmasher. Once the 2nd Beatmasher was activated and set anywhere in between 70% to 100% the Release Effect Knob wouldn't kill the effect.

-Row#4 / Encoder#1 is remapped for new Beatmasher combo (The effect is now more suitable for basic beat mashing).